Skip to main content
A

Anonymous

Dec 23, 2024

My dryer all the sudden won’t turn on?

My Kenmore dryer has always worked great, but today, when I put the clothes in and pressed the start button, nothing happened—it didn't even attempt to start. I checked the fuse in the fuse box; it was still on, but I reset it just to be sure, and still, nothing changed. Do you have any ideas about what could be wrong?

9 Answers

A
Anonymous

Dec 25, 2024

If it is electric than I would say the thermal fuse or door switch has gone bad, the thermal fuse on the electric dryers takes out the entire dryer, most models it is located on the back of the dryer, heres a pic of what it might look like http://store.appliancepartsworld.com/3392519.html , you can check it with a volt/ohm meter, it should show resistance(same as putting the two meter terminals together), if it is bad, check your vent line to make sure it is not plugged, the door switch, just make sure the arm clicks when you push on it, you can check this the same way as the thermal fuse, with the arm pushed in it should show resistance. Hope this helps.

This Site Might Help You.

RE:

My dryer all the sudden won’t turn on?

My Kenmore dryer has always worked great. Today I put the clothes in and hit the start button and nothing happened. I didn’t even try to start. So I went to the fuse box and checked the fuse. It was on, but I reset it anyway and still nothing. Any ideas what it might could be?

A
Anonymous

Feb 04, 2025

If it buzzes when you press the start button it is the door switch.

It it is just dead, other than power, you most likely lost the thermal fuse. Besides replacing the fuse (which is on the inside) you also want to check the hose behind the dryer and your venting to outside to determine why it ran hot and blew the fuse.

Good Luck

A
Anonymous

Dec 04, 2024

Close the door. Tightly. That will start your dryer.

There is a button that gets pressed when the door closes.

Easy to replace too!

Or the block where wires connect to the dryer can be cracked or the connection is loose. A robertson or square screwdriver should be all that you need.

Don’t forget to unplug first.

I
Ila Ryan

Dec 16, 2024

There should be another breaker outside the house since it is 220. Try next to the electric meter.

A
Anonymous

Feb 01, 2025

1. try unplugging it for a bit then plug it back in

2. it may have a thermal fuse that went bad

Want to answer this question?

Join our community to share your knowledge!

Related Questions

10
On a U.S. Nuclear submarine, is the Xo higher ranked than the Captain?

I was watching the movie "Crimson Tide" and became curious about the ranks within a U.S. nuclear submarine. Specifically...

2
What does the word ‘Kusabi’ mean?

I have encountered the term "Kusabi" in two different contexts: once in the video game Fatal Frame II and again in the s...

6
What is a Bandidos Nomad?

Who are the Nomads in the Bandidos Motorcycle Club?

6
What is the song with lyrics “do you wanna ride in the back seat of a caddy”?

I have the chorus of a song stuck in my head, and I can't figure out who sings it or what the song is. I've tried search...

4
What should I wear for Home Depot orientation tomorrow?

I just got hired for a part-time sales job at Home Depot, and I have my orientation tomorrow. I've never had a job where...

4
Where can I find the instructions for the Ikea Brimnes bed?

I’ve already checked the IKEA website, but they only provide instructions for the Brimnes bed with storage drawers. I sp...

2
Why its so quiet, is it midle of the night right now? what time is it?

Why is it so quiet? Is it the middle of the night right now? What time is it?

3
How tall is a ps4 game case?

What is the height of a PlayStation 4 game case?

7
I am looking for a free tattoo magazine or catalog?

I am looking for a free tattoo magazine or catalog. Are there any recommendations for where I can find one? I would appr...

7
What does the word “Kyrie” mean in the following context?

I came across the phrase "Kyrie among nations" and looked it up in the dictionary, but the definition doesn't seem to fi...